By A O News Service
BALASORE, June 07: Though Railway Board on Sunday recommended a CBI probe into Bahanaga train crash, but “It was entirely due to human error. We have identified the error and found the involvement of two persons,” a railway source told on condition of anonymity.
Bahanaga Bazar station where the derailment occurred has two mainline tracks – Up and Down lines – for trains to pass through and two loop lines used for a temporary halt to allow smooth movement of trains on the main lines.
After a goods train was allowed to stay on the Up loop line, the signal was given for the Coromandel Express on the Up mainline. Usually, after a train is allowed into the loop line by switching on the panel, a piece of track is moved from the mainline to the loop line and once the train is in, the switch is moved back in the route relay panel to ensure that the moved piece of track is returned to its original position.
But here the track piece did not return from the loop line to the mainline and the point was towards the loop line before the green signal was given for the Coromandel Express. As per the data logger at Kharagpur, the issue reflected on the panel at the station and a red light flashed for a few seconds, but the station manager present at that time somehow missed it.
As the piece of track, according to sources, had not returned to its original position (from the loop line to mainline) after the goods train moved on the loop line, the Coromandel Express that was moving at 128 kmph at the time came on the loop line and rammed into the stationary iron ore laden freight train. Had the station manager noticed the red light and taken measures, this crash could have been avoided, the sources said.
Describing the human error, a railway official said that prior to the accident, the mainline and loop line junction had developed some snags, which were repaired by a signal maintainer. “Possibly, the technician who repaired the circuit made a direct connection with the signal bypassing the procedures which is why the station manager could give the signal without knowing the track position.
The technician adopted a shortcut method to repair the fault. The station manager could have verified properly if the track movement is smooth at the junction after repair,” the official said.
